211
250 Ultra-wide 38° Rigid Frame by Wyatt Gatling. Made of
1020 DOM (Drawn Over Mandrel) steel tubing. Legs are 1
3
/
8
"
O.D., .125" thick wall and 8" stretch. Backbone is 1
1
/
2
"O.D.
with .219" thick wall and 26" long. 1" rear axle included. TIG
welded. Accepts 11" fender. Softail style oil tank and 250 rear
tire with full width 1.5" belt. Integral 5th bolt mounting within
reinforced offset transmission plate.
VT No. Type
Note1: Requires a 1
1
/
4
" engine-to-inner primary spacer.
Note 2: Requires Gas tank mounts, coil mounts and regulator
mounts must be determined by the builder.
250 Frame
Frame Inserts. Right angle design allows to be cut for neck or
rear axle plate reinforcements.
VT No. Type
Weld On Mount Tab Set for oil
tank and exhaust mounting.
200 Frame
200 Wide Drive Frame available with or without Bob mounts. Features rake of 34 degrees. 4" stretch downtubes. Made of 1026
DOM (Drawn Over Mandrel) steel tubing. Legs are 1.25" O.D. with .125" thick wall. Backbone is 1.500" O.D. with .187" thick wall.
Seat post is 1.500" with .187 wall. Included additionally rear axle and front oil tank mounts. Special features include TIG welded
at stress points. Accepts 9" fender and 1984-up flat side gas tanks. Accepts ST style oil tank, ST style rear brake 87-up and up
to 200 series tire with belt. Accepts 200 series tire with use of 1/2" offset kit not included.
VT No.
Style
With Mounts
Without Mounts
