1224
Crankshaft
Installers
Sprocket Shaft Timken Bearing Installer
Tool.
VT No. OEM
Year Model
1977-up Sportster
16-1760* 2.500 Long 1977-up Sportster
16-1761* 2.060 Long 1977-up Sportster
*Note: Sold separately for 1977-up use
Sprocket Shaft Bearing Removal &
Installation Tool. Removes and installs
engine sprocket shaft bearings from
crankcase. Use with 33416 driver handle.
Replaces 94547-80. 2 part set, 4 halves.
VT No. Item
Bearing Race Press Plug
is used to remove and
install Timken Bearing Outer
Race.
VT No. Fits
(97194-57)
Sprocket Shaft Seal & Lock Installers
for Big Twins.
VT No. OEM
Years
Application
Installs Nut & Seal
As Above, Jims
Installs seal only, Jims
install seal.
Main Bearing End Plug Tool allows the
setting of proper end play in Big Twin
Timken Bearing Assemblies by selection
of proper spacer from the catalog. Use
when refitting bearings or bearing sets on
late models when spacers are not includ-
ed. Not needed for our VT No. 12-0309 or
12-0310 Timken sets, these are pre-
spaced from the factory.
VT No. Fits
Sprocket Shaft Timken Bearing Inner
Race Puller.
VT No. OEM
Model
Timken Bearing Removers remove bear-
ing from shaft without removing shaft from
flywheels.
VT No. Fits
Sprocket Shaft Seal Installer use this kit
to install sprocket shaft seal to proper
depth, and for holding the seal perfectly
square, for a no leak fit. Driver sold sepa-
VT No. Use
16-0661 1995-up Sportster and Buell®
Buell®
Big Twin
Cam Seal
Installer
Tool can be
used to
remove or
install seal and will also remove cover
from case. Fits BT, 1970-up.
1990-up Big
Twin Snap
Ring
Remover will
remove the
Timken
Bearing outer
race snap ring
without dam-
age to the
case.
VT No.
Sprocket Shaft
Holder will hold the
flywheel in vise,
without left case
attached. Use on
Big Twin 1955-up.
By Jims.
Timken Bearing Simulator allows quick
and easy removal and replacement of fly-
wheel assembly in the left crankcase
when checking clearances before the final
assembly. Constructed of Delrin plastic.
Crank Pin Nut Clearance
Gauge.
VT No. Year
