1232
Jims Main Bearing Installer Tool. Allows proper installation
of transmission case main bearing by holding bearing square
to its bore. Use on 2006-up Dyna and 2007-up FXST-FLT
models.
Jims Main Drive
Gear Installer
Tool. This tool will
hold the main drive
gear square to its
bearing bore for
proper main drive
gear installation. Use on 2006-up Dyna and 2007-up FXST-
FLT models.
Jims Inner Cam Bearing Remover
Tool allows removal of needle bearing
and will also keep needles from falling
into engine. Use on 2006-up Dyna
and 2007-up FXST-FLT models.
Jims Main Drive Gear Bearing and Seal
Installer. This tool will hold bearings and seal
square to its bore for proper installation and
will also allow both to be installed to proper
depth. Use on all 2006-up Dyna and 2007-up
FXST-FLT models.
Jims Case Splitter. Use this tool
to break the case sealant by
pushing apart both case halves.
Use on 2006-up Dyna and 2007-
up FXST-FLT models.
Jims
Transmission
Door Removal
Tool use this tool
to pull complete
door with gears
and shafts from
transmission. Use on 2006-up Dyna and 2007-up FXST-FLT
models.
Jims Right Side Drive Transmission Trap Door
Puller Tool. Removes access door on all right side
drive transmissions.
2006-up Dyna/2007-up for FXST-FLT
Jims Cam Locking Tool allows
removal and torquing of cam sprocket
bolts by locking camshaft and crank-
shaft sprockets. Use on 2006-up
Dyna and 2007-up FXST-FLT models.
Starter Jackshaft Seal Installer Tool will easily allow align-
ment and installation of starter jackshaft seal (OEM#12066)
without distortion or damage to seal. For 1994-06 Big Twins
except 2006 Dyna.
Jims Transmission Main Drive
Gear Nut Wrench Tool. Use to
remove the 2 1/4" hex nut from
main drive gear which secures
the rear drive trans pulley. Use
with 1/2" drive ratchet. Use on all 2006-up Dyna and 2007-up
FXST-FLT models.
Jims Inner Cam Bearing
Installer Tool. Use this tool
to press in the two inner cam
bearings without damage to
bearings. Installs bearing to
proper depth in case. Use on
2006-up Dyna and 2007-up
FXST-FLT models.
Jims Primary Locking Tool use
this tool to lock clutch hub
sprocket to the front engine
sprocket. Allows removal or
torquing of clutch hub and
engine nuts. Use on all 2006-up
Dyna and 2007-up models.
Jims TC-88 Crankshaft Guide use to spread pinion
bearing rollers while reassembling right side engine
case on to flywheel assembly.
