Great Plains Logo

Select the Category


you would like to browse:


Home

  • 1232


1232
Jims Main Bearing Installer Tool. Allows proper installation
of transmission case main bearing by holding bearing square
to its bore. Use on 2006-up Dyna and 2007-up FXST-FLT
models.
VT No. 16-1355
Jims Main Drive
Gear Installer
Tool. This tool will
hold the main drive
gear square to its
bearing bore for
proper main drive
gear installation. Use on 2006-up Dyna and 2007-up FXST-
FLT models.
VT No. 16-1350
Jims Inner Cam Bearing Remover
Tool allows removal of needle bearing
and will also keep needles from falling
into engine. Use on 2006-up Dyna
and 2007-up FXST-FLT models.
VT No 16-1351
Jims Main Drive Gear Bearing and Seal
Installer. This tool will hold bearings and seal
square to its bore for proper installation and
will also allow both to be installed to proper
depth. Use on all 2006-up Dyna and 2007-up
FXST-FLT models.
VT No. 16-1353
Jims Case Splitter. Use this tool
to break the case sealant by
pushing apart both case halves.
Use on 2006-up Dyna and 2007-
up FXST-FLT models.
VT No. 16-1354
Jims
Transmission
Door Removal
Tool use this tool
to pull complete
door with gears
and shafts from
transmission. Use on 2006-up Dyna and 2007-up FXST-FLT
models.
VT No. 16-1358
Jims Right Side Drive Transmission Trap Door
Puller Tool. Removes access door on all right side
drive transmissions.
VT No. 16-1356
2006-up Dyna/2007-up for FXST-FLT
Jims Cam Locking Tool allows
removal and torquing of cam sprocket
bolts by locking camshaft and crank-
shaft sprockets. Use on 2006-up
Dyna and 2007-up FXST-FLT models.
VT No. 16-1352
Starter Jackshaft Seal Installer Tool will easily allow align-
ment and installation of starter jackshaft seal (OEM#12066)
without distortion or damage to seal. For 1994-06 Big Twins
except 2006 Dyna.
VT No. 16-1373
Jims Transmission Main Drive
Gear Nut Wrench Tool. Use to
remove the 2 1/4" hex nut from
main drive gear which secures
the rear drive trans pulley. Use
with 1/2" drive ratchet. Use on all 2006-up Dyna and 2007-up
FXST-FLT models.
VT No. 16-1359
Jims Inner Cam Bearing
Installer Tool. Use this tool
to press in the two inner cam
bearings without damage to
bearings. Installs bearing to
proper depth in case. Use on
2006-up Dyna and 2007-up
FXST-FLT models.
VT No. 16-1360
Jims Primary Locking Tool use
this tool to lock clutch hub
sprocket to the front engine
sprocket. Allows removal or
torquing of clutch hub and
engine nuts. Use on all 2006-up
Dyna and 2007-up models.
VT No. 16-1357
Jims TC-88 Crankshaft Guide use to spread pinion
bearing rollers while reassembling right side engine
case on to flywheel assembly.
VT No. 16-1281